No time for worrying, even there is a problem.
I had been thinking about preventing the feather keep coming out.
To be honest, the fashion show will be fine.
Just I am worrying for while I am sewing, because the coat needs to be moved inside out, up side down, turn, ironing... so it will be covered with messy feathers everywhere if I did not do anything before I go to the next step. I needed a solution at least until I finish to make it.
I tried several experimentation.
The perfect solution was using Hotmelt. It is a thin sheet of plastic and is attached with heat. It is like a clear fusing but do not make fabric hard. However, unfortunately I did not have enough Hotmelt and I have no idea where I can get them in a few days.
For temporary, put PVA glue was also fine. It makes the fabric slightly stiff, but it prevents a lot.
So I decided to do the way, before start sewing.
I tried to do my best, not only for this coat, but also for all the works which I have done for this module.
The last movie is here.
No comments:
Post a Comment